Specifications Index
MUSTANG SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | 58 amps at 2000 RPM | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Information | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 16 Lbs. | ||
| Thermostat R & I | |||
| 3.8L V6 | N/A | ||
| 4.6L V8 (VIN V) | N/A | ||
| 4.6L V8 (VIN X) | THERMOSTAT | ||
| Water Pump R & I | |||
| 3.8L V6 | WATER PUMP | ||
| 4.6L V8 (VIN V) | WATER PUMP | ||
| 4.6L V8 (VIN X) | WATER PUMP | ||
| Engine Mechanical | |||
| 3.8L V6 | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | 40-125 psi (2.8-8.8 kg/cm2 ) at 2500 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 4.6L V8 (VIN V) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | 20-45 psi (1.4-3.2 kg/cm2 ) at 1500 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 4.6L V8 (VIN X) | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | 20-45 psi (1.4-3.2 kg/cm2 ) at 1500 RPM with engine at normal operating temperature. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab.From within Manager or Service Writer, click the "30/60/90 Interval" or " Maint." button | ||
| Flywheel/Flex Plate Torque | |||
| 3.8L V6 | 59 Ft. Lbs. (80 N.m) IMPORTANT: Apply thread sealant to bolt threads. |
||
| 4.6L V8 (VIN V) | 63 Ft. Lbs. (85 N.m) | ||
| 4.6L V8 (VIN X) | 54-64 Ft. Lbs. (73-87 N.m) Tightening sequence: INSTALLATION |
||
| Fuel System | |||
| Fuel Filter Location | Under vehicle forward of fuel tank on right side, mounted in bracket. | ||
| Pressure Release Procedure | |||
| 3.8L V6 | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| 4.6L V8 (VIN V) | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| 4.6L V8 (VIN X) | FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS | ||
| Pressure Specification (KOEO) | |||
| 3.8L V6 | 35-65 psi (240-448 kPa) | ||
| 4.6L V8 (VIN V) | 35-65 psi (240-448 kPa) | ||
| 4.6L V8 (VIN X) | 35-65 psi (240-448 kPa) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE | ||
| Fuel Filter R & I | REMOVAL & INSTALLATION (MUSTANG) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | |||
| 3.8L V6 | FIRING ORDER & TIMING MARKS | ||
| 4.6L V8 | Coil On Plug | ||
| Spark Plugs | |||
| 3.8L V6 | |||
| Type | Original spark plug: Motorcraft AWSF-42E Service spark plug: Motorcraft AWSF-42EE |
||
| Gap | 0.052-0.056 In. (1.32-1.42 mm) | ||
| Torque | 11 Ft. Lbs (15 N.m) | ||
| 4.6L V8 (DOHC) | |||
| Type | Motorcraft AWSF-32E Or AWSF-32EE | ||
| Gap | 0.052-0.056 In. (1.32-1.42 mm) | ||
| Torque | 11 Ft. Lbs. (15 N.m) | ||
| 4.6L V8 (SOHC) | |||
| Type | Motorcraft AWSF-32P Or AWSF-32PP | ||
| Gap | 0.052-0.056 In. (1.32-1.42 mm) | ||
| Torque | 11 Ft. Lbs. (15 N.m) | ||
| Starting | |||
| Starter | STARTER MOTOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 85-105 Ft. Lbs. (115-142 N.m) | ||