Non-Generic (Ford Specific) OBD-II PIDs

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:

Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
Select PID/DATA MONITOR & RECORD.
Turn ignition switch to ON position or start engine and allow to idle.
Follow operating instructions from scan tool menu.
Select PIDs and press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST.