Connecting Rod
WARNING: This page is about a different variant/trim than selected.
ENGINE - 2.0L SPI CONNECTING ROD SPECIFICATION
| Item | Specification (mm) |
|---|---|
| Connecting rod bearings clearance to crankshaft | 0.020-0.065 |
| Bearing wall thickness (std.) | 1.476-1.488 |
| Clearance of crankshaft without cylinder head | desired - 0.0457-0.0660 |
| Clearance of crankshaft without cylinder head | allowable - 0.0461-0.0859 |
| Clearance of crankshaft with cylinder head | desired - 0.0279-0.0483 |
| Clearance of crankshaft with cylinder head | allowable - 0.0276-0.0674 |
| Bearing wall thickness | 2.117-2.129 |
| Connecting rod piston pin bore diameter | 20.570 -20.610 |
| Crankshaft bearing bore diameter | 46.89-46.91 |
| Out-of-round limit - piston pin bore | .008 |
| Taper limit piston pin bore | 0.0038/25.4 |
| Length (center to center) | 131.905-131.975 |
| Out-of-round-limit - bearing bore | 0.010 |
| Taper limit - bearing bore | 0.010 |
| Alignment bore-to-bore (max. differential) twist | 0.05 |
| Alignment bore-to-bore (max. differential) bend | 0.038 |
| Side clearance (assembled to crank) standard | 0.092-0.268 |
| Side clearance (assembled to crank) service limit | 0.356 |