Cylinder Block
WARNING: This page is about a different variant/trim than selected.
ENGINE - 2.0L SPI CYLINDER BLOCK SPECIFICATION
| Item | Specification (mm) |
|---|---|
| Head gasket surface finish roughness height (CLA) | 3.8-2.0 |
| Head gasket surface finish roughness height cut-off | 0.8 |
| Dowel height chamfer | 0.8x30° |
| Dowel height chamfer total | 12.5 |
| Cylinder bore diameter | 84.8 |
| Piston to cylinder bore clearance | 0.020-0.040 |
| Surface finish (RA) each bore min. | 15-38 |
| Average of all bores of a cylinder block (Ra) min. | 20-30 |
| Out-of-round limit | 0.025 |
| Tappet limit | 0.013 |
| Main bearing bore diameter @ +/- 30° PF Bearing Cap P/L | 62.2835-62.3145 |
| Main bearing bore diameter other than above | 62.2935 +/- .0100 |