Power Mirror Control Switch
Remove power mirror control switch. See POWER MIRROR CONTROL SWITCH under REMOVAL & INSTALLATION. While operating switch in specified position, measure resistance between power mirror control switch connector C527 terminals. See POWER MIRROR CONTROL SWITCH TEST table. See Fig 1. Resistance in all tests should be less than 5 ohms. If switch fails any portion of test, replace switch.
POWER MIRROR CONTROL SWITCH TEST
| Switch Position(1) | Measure Between Terminals No. | |||
|---|---|---|---|---|
| Left Mirror | ||||
| Up | 1 & 6; 5 & 7 | |||
| Down | 1 & 7; 5 & 6 | |||
| Left | 1 & 6; 4 & 5 | |||
| Right | 1 & 4; 5 & 6 | |||
| Right Mirror | ||||
| Up | 1 & 6; 5 & 8 | |||
| Down | 1 & 8; 5 & 6 | |||
| Left | 1 & 6; 3 & 5 | |||
| Right | 1 & 3; 5 & 6 | |||
|
||||