LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Supplemental Inflatable Restraint System) >> Removal And Installation >> Restraints Control Module (RCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Restraints Control Module (RCM): Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: The tightening torque of the air bag RCM retaining bolts is critical for correct system operation.
  1. Position the RCM and install the 3 bolts.
    • Tighten to 11 Nm (8 lb-ft).
  2. Connect the small RCM electrical connector.
  3. Make sure the connector position assurance lever is in the full release position before attempting to connect the large RCM electrical connector.
    Fig 1: Identifying Connector Position Assurance Lever
    G04622828Courtesy of FORD MOTOR CO.
    4. CAUTION: Putting the large RCM electrical wiring connector into the RCM on an angle can cause bad electrical connections and damage components.
    NOTE: The RCM has been removed for clarity.
  4. Position the large RCM electrical wiring connector into the RCM.
      CAUTION: Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the RCM before using the lever to fully seat the connector.
      Fig 2: Positioning Large RCM Electrical Connector Into RCM
      G04622829Courtesy of FORD MOTOR CO.
    • With the large RCM electrical wiring connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and a slight resistance is felt.
    5. NOTE: The RCM has been removed for clarity.
  5. Connect the large RCM electrical wiring connector.
    • Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
      • Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
        Fig 3: Identifying Connector Thumb Tab Locked In Place
        G04622830Courtesy of FORD MOTOR CO.
  6. Position back the carpet on the LH and RH tunnel to its original position.
  7. Install the lower LH center instrument panel finish panel.
  8. Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
scientia non olet · About LEMON Manuals