LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> Suspension >> Wheel Alignment Specifications & Procedures >> Wheel Alignment Procedures >> Toe-In Adjustment >> Front
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Toe-In Adjustment: Front

  1. Start the engine and center the steering wheel. Turn the engine off, and hold the steering wheel in the "straight forward" position by attaching a rigid link from the steering wheel to the brake pedal. Remove the clamps from the bellows boot. See Fig 1 .
  2. Clean and lubricate the nuts and the tie-rod end threads. Loosen the nuts. Do not allow the bellows boot to twist when the tie-rod is rotated. Rotate the tie-rods to obtain the correct toe setting. See WHEEL ALIGNMENT SPECIFICATIONS  .
  3. Start the engine and recenter the steering wheel. Recheck the toe settings and adjust if necessary. Tighten the nuts to specification. See TORQUE SPECIFICATIONS  . Install the clamps.
Fig 1: Adjusting Toe (Left Side Is Shown; Right Side Is Similar)
G00281173Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals