Checking Fluid Level

NOTE: When filling a dry transmission and converter start with a minimum of 5 quarts (4.7L). Fill transmission to correct fluid level, using clean ATF.

NOTE: To obtain an accurate transmission fluid level check, drive vehicle until it is at normal operating temperature, about 20 miles. If vehicle has been operated for an extended period at high speeds, in city traffic during hot weather or pulling a trailer, vehicle should be turned OFF for about 30 minutes to allow transmission fluid to cool down before checking.

Drive vehicle for about 20 miles or until it reaches operating temperature 150-170°F (66-77°C). With vehicle on level ground, apply parking brake, and run engine at idle. Shift gear selector lever through all ranges, ending in Park.
Fluid level should be in crosshatch area on dipstick. If transmission is at room temperature, fluid level should be between 2 dimples on bottom of dipstick.
Add fluid as necessary. See RECOMMENDED FLUID . DO NOT overfill. Check condition of fluid for contamination and burned smell. Ensure dipstick is fully installed.