Switch - Memory Set

WARNING: This page is about a different car, the 2003 Mercury Mountaineer and 2003 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Memory Set Switch Terminals

Courtesy of FORD MOTOR CO.

Remove the memory set switch.

Measure the resistance between the following indicated terminals while pressing the requested switches.

Fig 2: Memory Set Switch Terminals Reference Table (1 Of 2)

Courtesy of FORD MOTOR CO.

Fig 3: Memory Set Switch Terminals Reference Table (2 Of 2)

Courtesy of FORD MOTOR CO.

The resistance should be less than 5 ohms for each switch position.

If the resistance is not less than 5 ohms for each switch, install a new switch; otherwise, return to the calling Pinpoint Test.

NOTE: Refer to Multimeter User's Manual for testing diodes.

To check the memory set switch LED, connect the positive meter lead to terminal 8 and the negative lead to terminal 9. The meter should indicate greater than 0.3 volts. Reversing the leads, the meter should read OL.

If the meter readings are not as indicated above, install a new switch; otherwise, return to the calling Pinpoint Test.