LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> Escape 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 407 (Electronic Engine Control System) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the powertrain control module (PCM) cover.
    1. Loosen the bolt and disconnect the electrical connector.
    2. Remove the nuts and the cover.
    Fig 1: Removing Powertrain Control Module Cover
    G02740139Courtesy of FORD MOTOR CO.
  3. Remove the PCM.
    Fig 2: Removing PCM
    G02740140Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals