Recommended Procedure (Econoline)
WARNING: This page is about a different variant/trim than selected.
If necessary, remove generator and bracket to access pipe plug. Remove 1/8" pipe plug from top front of right cylinder head. See Figure. Install fuel pressure gauge. Start engine. Check fuel pressure with a full load on engine. DO NOT brake torque engine for more than 10 seconds. If fuel pressure is 45-80 psi (310-552 kPa), fuel pressure is okay. If fuel pressure is not 45-80 psi (310-552 kPa), replace right fuel check valve. Check valve is located in rear of right cylinder head between fuel inlet line and cylinder head.