Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure applies to Fusion/Milan with Sony® sound and MKZ with THX® sound only. For all other amplifiers, refer to the
appropriate procedure in this service information.
- Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION -- FUSION MILAN & MKZ article.
- Remove the 4 pushpins and the RH luggage compartment trim panel.
- Disconnect the audio DSP module electrical connectors.
- Remove the 3 bolts and the audio DSP module.
- To install, tighten to 9 Nm (80 lb-in).
- To install, reverse the removal procedure.
NOTE:
Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
- Download the configuration information to the audio DSP module. For additional information, refer to PMI in MODULE CONFIGURATION -- FUSION MILAN & MKZ article.