Vehicle Security Module: Removal

NOTE: Prior to removal of the vehicle security module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .

Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the pushpin and the RH interior kick panel.
Disconnect the three vehicle security module electrical connectors.

Fig 1: Disconnecting Three Vehicle Security Module Electrical Connectors
Courtesy of FORD MOTOR CO.
Remove the two screws and the vehicle security module.

Fig 2: Removing Two Screws And Vehicle Security Module
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.