Turning Effort Test
NOTE:
Make sure that the front wheels are properly aligned and the tire pressure is correct before checking the effort
- Park the vehicle on dry concrete and set the parking brake.
- Insert a thermometer into the power steering pump reservoir.
- Idle the engine for two to three minutes. Turn the steering wheel from stop-to-stop several times to warm the fluid to 50-60° C (122-140°F).
- With the engine running, attach special tool 211-034 (T74P-3504-Y) to the rim of the steering wheel.
- Measure the pull required to turn the steering wheel one complete revolution in each direction. Refer to GENERAL SPECIFICATIONS Turning Effort.
CAUTION:
Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur