April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test NC: Ignition Engine Speed Input Circuit: Testing

NOTE: For additional testing information, see DIAGNOSTIC AIDS .

1) For KOEO & Continuous Memory Only DTC P0320: Erratic Ignition
The ignition engine speed sensor input signal to PCM is continuously monitored. The test fails when the signal indicates that two successive erratic Profile Ignition Pickup (PIP) pulses have occurred. Possible causes are:
- Loose wires/connectors.
- Arcing secondary ignition components (coil, wires and plugs).
- On board transmitter (2-way radio).
Ensure 2-way radio antenna and all harness connections are properly installed and routed. If any faults were present, repair as necessary. If vehicle will not start, go to TEST A, step 1) . If fault is intermittent, go to TEST Z, step 1). If vehicle will start and no faults were present, check for missing PIP signal. Go to TEST JD, step 1) .