PATS Function

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

The PATS function is controlled by the PCM. PATS uses the PCM to carry out all of the PATS functions such as receiving the identification code from the PATS key, controlling the starter and fuel injectors enable, and initiates the key interrogation sequence when the ignition key is turned to the ON or START position. All elements of PATS must be functional before the vehicle will start. If any of the components are not working correctly, the vehicle will not start. If the PCM must be replaced for any reason (PATS concerns or driveability concerns), the PATS keys must be programmed into the new PCM. For additional information, refer to Key Programming Using Diagnostic Equipment in this section.

PATS is active only for a few seconds when the vehicle is starting. It is not a PATS concern if the vehicle stalls after it has been running for a minimum of 3 seconds. PATS will not disable a running vehicle.

PATS is not compatible with aftermarket remote start systems, which allow the vehicle to be started from the exterior of the vehicle. These systems may reduce the security of the vehicle, and also may be the cause of no-start concerns. Remote start systems must be removed from the vehicle before any PATS-related no-start concerns are investigated.

PATS will disable the vehicle from starting if there is:

a damaged PATS key.
an unprogrammed PATS key.
a non-encoded key (a conventional key or one that does not have any electronics).
damaged wiring.
a damaged transceiver.
a damaged PCM.