Torque Converter Stator Support: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the converter impeller hub seal.

Fig 1: Removing Converter Impeller Hub Seal
Courtesy of FORD MOTOR CO.
Remove the bearing outer race.
1. Use a pin punch and hammer to carefully drive the bearing outer race from the torque converter stator support.
Fig 2: Removing Bearing Outer Race From Torque Converter Stator Support
Courtesy of FORD MOTOR CO.
Remove the stator support O-ring.

Fig 3: Removing Stator Support O-Ring
Courtesy of FORD MOTOR CO.