LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2004 >> Excursion 6.0 P, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1848 (Electronic Engine Control System - 2.3L - (Hybrid)) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the PCM and the stud bolts.
    • Tighten to 6 Nm (53 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Attach the wiring harness retainer to the PCM stud bolt and install the nut.
    • Tighten to 6 Nm (53 lb-in).
  4. Attach the ground strap to the PCM stud bolt and install the nut.
    • Tighten to 6 Nm (53 lb-in).
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION article.
scientia non olet · About LEMON Manuals