LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2004 >> Excursion 6.0 P, RWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Inflatable Restraint System - Air Bag Deactivation Procedures >> Disabling & Activating Air Bag System >> FREESTAR & MONTEREY >> Activating System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Activating System

  1. Remove the RCM fuse F2.17 (10A) from the SJB. Disconnect negative battery cable. Wait at least one minute for backup power supply to deplete stored energy. Remove the restraint system diagnostic tool from the vehicle harness side of the driver seat side air bag module electrical connector. Connect the driver seat side air bag module electrical connector. Repeat procedure for passenger side air bag module.
  2. Remove the restraint system diagnostic tool from the vehicle harness side of the driver side safety canopy module electrical connector. From between the headliner and the roof of the vehicle, just to the front of the "C" pillar, connect the driver side safety canopy module electrical connector. Position the coat hook and install the screw. Install the coat hook cover. Position and install the "C" pillar trim panel. Attach the quarter trim panel. Attach the weatherstrip. Position the safety belt guide and install the bolt. Install the safety belt guide cover.
  3. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger side safety canopy module electrical connector. Connect the passenger side safety canopy module electrical connector. Position and install the "D" pillar trim panel. Attach the quarter trim panel. Attach the weatherstrip. Position the attachments and install the screws. Position the safety belt guide and install the bolt. Install the safety belt guide cover.
  4. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag module electrical connector. Through the glove compartment opening, connect the passenger air bag module electrical connector. Close the glove compartment.
  5. Remove the restraint system diagnostic tool from the clockspring electrical connector at the top of the steering column. Through the steering wheel access door opening, connect the driver air bag module electrical connector. Close the steering wheel access door.
    6. WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the battery ground cable is connected.
  6. Ensure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS components are connected. Turn the ignition switch from off to on. Install the RCM fuse F2.17 (10A) to the SJB and install the cover. Reconnect negative battery cable. Recheck system operation. Perform SYSTEM OPERATION CHECK . Reprogram USER 1 and USER 2 preset radio frequencies and set clock.
scientia non olet · About LEMON Manuals