Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Vehicles without navigation require Programmable Module Installation (PMI) when a new module is being installed. For vehicles without navigation, the Front Display Interface Module (FDIM) is not a stand-alone module.
- For vehicles without navigation, upload the FDIM configuration information to the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION .
- Remove the instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the 4 screws and the FDIM
.
- Disconnect the electrical connectors.NOTE: For vehicles with navigation, make sure not to bend the video cable when removing the FDIM .
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
- For vehicles without navigation, download the configuration information to the FDIM . For additional information, refer to PMI in MODULE CONFIGURATION .