ABS Module Calibration List
NOTE:
The need to recalibrate the ABS module is indicated by the active/fail lamp flashing and the presence of DTC C1998. For additional information, refer to the ANTI-LOCK BRAKE SYSTEM (ABS) MODULE CALIBRATION for other service actions requiring recalibration. The lamp will flash after the DTCs on the ABS calibration list are cleared.
ABS MODULE CALIBRATION LIST
| DTC | Description | ABS Module Calibration |
|---|---|---|
| C1277 | Steering Wheel Angle 1 and 2 Circuit Failure | YES |
| C1278 | Steering Wheel Angle 1 and 2 Signal Fault | YES |
| C1279 | Yaw Rate Sensor Circuit Failure | YES |
| C1280 | Yaw Rate Sensor Circuit Fault | YES |
| C1281 | Lateral Accelerometer Circuit Failure | YES |
| C1282 | Lateral Accelerometer Signal Fault | YES |
| C1285 | Booster Solenoid Circuit Failure | YES |
| C1287 | Booster Pedal Force Switch Circuit Failure | YES |
| C1288 | Pressure Transducer Main/Primary Input Circuit Failure | YES |
| C1440 | Pressure Transducer Main/Primary Signal Fault | YES |
| C1730 | Reference Voltage Out of Range (+5 V) | YES |
| C1991 | Module Configuration Failure | YES |
| C1996 | Active Yaw System (ABS) Disabled | YES |
| C2769 | Longitudinal Acceleration Sensor Circuit Failure | YES |
| C2770 | Longitudinal Acceleration Sensor Signal Fault | YES |
| C2777 | Sensor Cluster Bus Failure | YES |
| C2778 | Sensor Cluster Power Supply Failure | YES |