System Specifications

Cylinder Block
Cylinder bore diameter 87.5-87.53 mm (3.444-3.445 inch)
Cylinder bore maximum out-of-round 0.008 mm (0.0003 inch)
Main bearing bore diameter 57.020-57.038 mm (2.244-2.245 inch)
Head gasket surface flatness 0.1 mm/general 0.05 mm/200 x 200 (0.0003 in./general) (0.0019 in./7.87 x 7.87)

Crankshaft
Main bearing journal diameter 51.980-52.000 mm (2.046-2.047 inch)
Production repair 51.730-51.750 mm (2.036-2.037 inch)
Main bearing clearance 0.019-0.035 mm (0.0007-0.0013 inch)
Connecting rod journal diameter 49.980-50.000 mm (1.967-1.968 inch)
Production repair 49.730-49.750 mm (1.957-1.958 inch)
End play 0.22-0.43 mm (0.008-0.016 inch)

Connecting Rod
Bearing clearance 0.027-0.052 (0.001-0.002 inch)
Bearing thickness 1.496-1.520 mm (0.058-0.059 inch)
Crank bore diameter 53.025-53.045 mm (2.087-2.088 inch)
Pin bore diameter 20.965-20.985 mm (0.825-0.826 inch)
Length (center to center) 154.8 mm (6.094 inch)
Side clearance 1.95-3.05 mm (0.076-0.120 inch)
Axial clearance 0.14-0.36 mm (0.005-0.014 inch)

Piston
Diameter (1) 87.5-87.51 mm (3.444-3.445 inch)
Diameter (2) 87.51-87.52 mm (3.4452-3.4456 inch)
Diameter (3) 87.52-87.53 mm (3.444-3.446 inch)
Piston-to-bore clearance 0.025-0.045 mm (0.0009-0.0017 inch)
Ring groove width - top 1.203-1.205 mm (0.0473-0.0474 inch)
Ring groove width - 2nd 1.17-1.19 mm (0.0.460-0.0468 inch)
Ring groove width - oil 2.501-2.503 mm (0.0984-0.0985 inch)
Piston skirt coating thickness 0.008-0.020 mm (0.0003-0.0007 inch)

Rings
Width - top 1.17-1.185 mm (0.0460-0.0466 inch)
Width - 2nd 1.197-1.199 mm (0.0471-0.0472 inch)
Width - oil 2.38-2.45 mm (0.093-0.096 inch)
Ring gap (in bore) - top 0.16-0.31 mm (0.006-0.012 inch)
Ring gap (in bore) - 2nd 0.33-0.48 mm (0.012-0.018 inch)
Ring gap (in bore) - oil 0.2-0.7 mm (0.007-0.027 inch)

Tighten the crankshaft pulley bolt in two stages:
Stage 1 100 Nm (74 ft. lbs.)
Stage 2 Tighten an additional 90 degrees (1/4 turn)