Drive Mode Procedure for TCC
WARNING: This page is about a different variant/trim than selected.
Follow operating instructions from the NGS menu screen:
- Select "Output State Control."
- Select "Trans - Drive Mode."
- Select "PIDs" to be monitored.
- Monitor all selected PIDs during test.
- Select "Parameters - TCC."
- Select "ON" to turn TCC ON.
- Press "SEND" to send command.
- Select "OFF" to turn TCC OFF.
- Press "SEND" to send command.
- Select "XXX" to cancel at any time.
- Press "SEND" to send command.