Specifications Index
THUNDERBIRD SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut | ||
| Rear | 203 Ft. Lbs. (275 N.m) | |
| Battery | 650 CCA, rated at 0° F 72 amp/hr | |
| Brakes | ||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | DRIVE BELT | |
| Belt Routing | DRIVE BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 16 psi (110 kPa) | |
| Thermostat R & I | THERMOSTAT HOUSING | |
| Water Pump R & I | WATER PUMP | |
| Engine Mechanical | ||
| Compression | COMPRESSION TEST -- COMPRESSION GAUGE CHECK | |
| Oil Pressure | Oil pressure minimum at 400 rpm (normal operating temperature) 61-73 psi (413-482 kPa) | |
| Overhaul | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | FLEXPLATE OR FLYWHEEL AND CRANKSHAFT REAR SEAL | |
| Fuel System | ||
| Fuel Filter Location | Located behind the left front wheel well splash shield. | |
| Fuel Filter R & I | REMOVAL AND INSTALLATION | |
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | |
| Pressure Specification | FUEL PRESSURE SPECIFICATIONS | |
| Fuel Pressure Test Procedure | A: No Start STEP A10 CHECK THE FUEL PRESSURE | |
| Ignition | ||
| Firing Order & Cylinder Identification | Firing order: 1-5-4-2-6-3-7-8. See FIRING ORDER & CYLINDER IDENTIFICATION . | |
| Ignition Coil (Cylinder Identification) | Coil on plug | |
| Ignition Wires (Routing) | Coil on plug | |
| Spark Plugs | ||
| Type | Motorcraft AGSP-32F | |
| Gap | .039-.043 In. (1.0-1.1 mm) | |
| Torque | 20 Ft. Lbs. (27 N.m) | |
| Starting | ||
| Starter | NA | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | |