Inspection And Verification: Notes
WARNING:
If equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM
for important safety warnings.
NOTE:
Before starting electrical diagnosis, check for mechanical binds by manually operating the door locks. Operate lock system several times from each switch while observing the operation of all door locks. Be sure battery is fully charged.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical and electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Binding latches
- Battery junction box (BJB) fuse 8 (20A)
- Central junction box (CJB) fuse(s):
- 10 (5 A)
- 18 (10A)
- 25 (10A)
- Circuitry
- Connectors
- Door lock actuator
- Door lock control switch
- Keyless entry keypad
- Luggage compartment lid release switch
- Luggage compartment lid release solenoid
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the diagnostic tool to the data link connector and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
- Carry out the diagnostic tool data link test. If diagnostic tool responds with:
- SCP or ISO circuit fault; all electronic control units no response/not equipped, refer to MULTIFUNCTION ELECTRONIC MODULES .
- No response/not equipped for the DDM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- No response/not equipped for the LCM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the DDM and LCM.
- If the DTCs retrieved are related to the concern, go to the DRIVE DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX or LIGHTING CONTROL MODULE (LCM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX to continue diagnostics.
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .