Pinpoint Test A: Accelerator Pedal Is Hard To Push Down
WARNING: This page is about a different car, the 2005 Mercury Sable and 2005 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
- A1 CHECK ACCELERATOR PEDAL AND CABLE TRAVEL
- Disconnect the cable end from the throttle body linkage.
- Make sure the disconnected end of the accelerator cable does not come in contact with any of the surrounding parts.
- Operate the accelerator pedal and shaft by hand.
- Is the full pedal travel to wide open throttle (WOT) restricted by carpeting, floor mats or other obstruction?
- Yes : REMOVE the obstruction to pedal travel.
- No : GO to A2.
- A2 CHECK ACCELERATOR PEDAL AND CABLE FOR BINDING
- With cable end disconnected, operate the pedal by foot.
- Is the pedal operation smooth?
NOTE: The accelerator cable should not be lubricated and is not a repairable item.- Yes : See INTRODUCTION - GASOLINE article , for diagnosis and testing of the throttle body.
- No : CHECK the accelerator pedal and shaft for free operation. INSTALL new accelerator cable as necessary. If accelerator pedal and shaft have a free operation, GO to PINPOINT TEST B .