LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System - 2.3L - (Except Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM cowl seal.
  2. Install the PCM and the 2 stud bolts.
    • Tighten to 6 Nm (53 lb-in).
  3. Connect the 3 PCM electrical connectors.
  4. Position the wiring harness and install the PCM stud bolt nut.
    • Tighten to 6 Nm (53 lb-in).
  5. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  6. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  7. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. For additional information, refer to ANTI-THEFT - PATS .
  8. For automatic transmission/CVT equipped models, carry out the Transaxle Drive Cycle Test. For additional information, refer to AUTOMATIC TRANSAXLE-TRANSMISSION - CD4E .
scientia non olet · About LEMON Manuals