LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Power Steering System >> Removal And Installation >> Power Steering Control (PSC) Module >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

  1. Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - HYBRID .
  2. Remove the battery junction box (BJB) bracket nuts on the strut tower.
    • Position the BJB aside.
  3. Disconnect the power steering control module electrical connectors.
  4. Remove the 2 power steering control module nuts.
    • To install, tighten to 23 Nm (17 lb-ft).
  5. Remove the power steering control module ground cable bolt.
  6. Remove the power steering control module nuts from inside the vehicle.
    • To install, tighten to 23 Nm (17 lb-ft).
  7. Remove the power steering control module.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals