LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Excursion 6.8 S, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> MULTIFUNCTION Electronic Modules System >> Diagnosis And Testing >> Vehicle Security Module >> Inspection and Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection and Verification

  1. Verify the customer concern.
  2. Visually inspect for obvious signs of electrical damage:
    VISUAL INSPECTION CHART

    Electrical
    Central junction box (CJB) fuse(s):
    • - 19 (10A)
    • - 102 (30A)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • CAN, ISO, SCP or UBP circuits fault; all electronic control units no response/not equipped, REFER to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for vehicle security module, C Test A.
    • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out self-test diagnostics for the vehicle security module.
  7. If the DTCs retrieved are related to the concern, go to the DIAGNOSTIC TROUBLE CODE CHART  to continue diagnostics.
  8. If no DTCs related to the concern are retrieved, refer to the appropriate information in the Workshop Manual to continue diagnostics.
scientia non olet · About LEMON Manuals