Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
- Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE:
When installing a new ABS module it must be configured using the vehicle as-built data and calibrated. For additional information, refer to MODULE CONFIGURATION
.
- Remove the hydraulic control unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
- Remove the 3 ABS module screws.
- To install, tighten to 2 Nm (18 lb-in).
- Remove the ABS module.
- To install, reverse the removal procedure.