LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2005 >> Expedition RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Electronic Engine Control System) >> Removal And Installation >> Throttle Position (TP) Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Position (TP) Sensor: Installation

WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    CAUTION:
    1. Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
    2. Do not use a high speed driver to install the new screws or damage to the TP sensor can occur.
    NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.
  1. Position the new TP sensor and install the 2 new screws.
    • Tighten to 3 N.m (27 lb-in).
  2. Connect the TP sensor electrical connector.

    3. Navigator vehicles 

  3. Install the air cleaner and air cleaner inlet pipe. For additional information, refer to REMOVAL AND INSTALLATION .

    4. All vehicles 

  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals