Specifications Index
EXPLORER & MOUNTAINEER SPECIFICATIONS INDEX
| System | Specification/Procedure | ||||
|---|---|---|---|---|---|
| Air Conditioning | |||||
| Service | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Axle Nut/Hub Nut | |||||
| Front | 184 lb.ft.(250 Nm) | ||||
| Battery | GENERAL SPECIFICATIONS | ||||
| Brakes | |||||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||||
| Disc Brakes | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Charging | |||||
| Generator | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Drive Belts | |||||
| Adjustment | COMPONENT TESTS | ||||
| Belt Routing | ACCESSORY DRIVE | ||||
| Engine Cooling | |||||
| General Service Specifications | GENERAL SPECIFICATIONS | ||||
| Radiator Cap Pressure | 13-18 psi (89-124 kPa) | ||||
| Thermostat R & I | |||||
| 4.0L | THERMOSTAT - 4.0L SOHC | ||||
| 4.6L | THERMOSTAT - 4.6L (2V) | ||||
| Water Pump R & I | |||||
| 4.0L | COOLANT PUMP - 4.0L SOHC | ||||
| 4.6L | COOLANT PUMP - 4.6L | ||||
| Engine Mechanical | |||||
| 4.0L | |||||
| Compression | COMPRESSION TEST - COMPRESSION GAUGE CHECK | ||||
| Oil Pressure | 15 psi (103 kPa) minimum oil pressure at normal temperature and 2000 RPM. | ||||
| Overhaul | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| 4.6L | |||||
| Compression | COMPRESSION TEST - COMPRESSION GAUGE CHECK | ||||
| Oil Pressure | 20-45 psi (138-310 kPa) hot @ 1500 RPM | ||||
| Overhaul | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||||
| Flywheel/Flex Plate Torque | |||||
| 4.0L | Step 1: 10 lb.ft. (13 Nm.) Step 2: 52 lb.ft. (71 Nm.) |
||||
| 4.6L | 59 lb.ft. (80 Nm.) | ||||
| Fuel System | |||||
| Fuel Filter Location | On leading edge of fuel tank on right side of vehicle, mounted behind fuel filter shield. | ||||
| Fuel Filter R & I | REMOVAL AND INSTALLATION | ||||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||||
| Pressure Specification | FUEL SYSTEM SPECIFICATIONS | ||||
| Fuel Pressure Test Procedure | A: No Start STEP A10 CHECK THE FUEL PRESSURE | ||||
| Ignition | |||||
| Firing Order & Cylinder Identification | |||||
| 4.0L | FIRING ORDER & CYLINDER IDENTIFICATION | ||||
| 4.6L | FIRING ORDER & CYLINDER IDENTIFICATION | ||||
| Ignition Coil (Cylinder Identification) | |||||
| 4.0L | COIL PACK | ||||
| 4.6L | Coil On Plug | ||||
| Ignition Wires (Routing) | |||||
| 4.0L | N/A | ||||
| 4.6L | Coil On Plug | ||||
| Spark Plugs (1)SEE FOOTNOTE | |||||
| 4.0L | |||||
| Type LH Type RH |
Motorcraft AGSF-22PM Motorcraft AGSF-22PGM |
||||
| Gap | .061-.068 In. (1.57-1.73 mm) | ||||
| Torque | 13 ft.lbs. (17 N.m) | ||||
| 4.6L | |||||
| Type | Motorcraft AGSF-32P | ||||
| Gap | .052-.056 In. (1.32-1.42 mm) | ||||
| Torque | 13 ft.lbs. (18 N.m) | ||||
| Starting | |||||
| Starter | GENERAL SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Wheel Alignment | |||||
| Adjustment Specifications | ALIGNMENT SPECIFICATIONS | ||||
| Torque | TORQUE SPECIFICATIONS | ||||
| Wheel & Tire | |||||
| Wheel Lug Nut Torque | 100 ft.lbs. (135 N.m) | ||||
|
|||||