Dual Automatic Temperature Control Module - Diagnostic Methods: Notes

The dual automatic temperature control system must be diagnosed by first retrieving any DTCs, if present.

• An on-demand (hard fault) DTC indicates that the fault is currently present. An on-demand DTC suggests a wiring fault, disconnected connector, or component failure.
• A continuous (intermittent) DTC alone (corresponding on-demand DTC is not present) indicates that the fault is an intermittent condition and may not be currently present. A continuous only DTC suggests a poor wiring connection, loose pin or terminal, or intermittent component failure.

On-demand (hard fault) or continuous (intermittent fault) DTCs can be retrieved using a diagnostic tool. If using a diagnostic tool, refer to the diagnostic tool operating manual.

On-demand DTCs can also be retrieved by carrying out the Dual Automatic Temperature Control Module on-demand Self-Test. To retrieve and/or clear continuous DTCs carry out the Dual Automatic Temperature Control Module - Retrieve Continuous DTCs procedure. Always carry out the Dual Automatic Temperature Control Module on-demand Self-Test before retrieving continuous DTCs.

If no DTCs are present, GO to SYMPTOM CHART  for the appropriate diagnostic action.