Remote Transmitter Programming

NOTE: A maximum of 4 remote keyless entry (RKE) transmitters can be programmed to the vehicle. Programming must be done at the same time for all the RKE transmitters.

NOTE: Before entering the RKE transmitter programming mode, make sure the vehicle battery is fully charged and the anti-theft system is not armed or triggered (if equipped).

Close all doors to make sure conflicting chimes do not sound during programming.
Turn the ignition switch from position I to position II 4 times within 6 seconds.
Turn the ignition switch to position 0.
A chime sounds that indicates the learning mode has been accessed and it is possible to program the RKE transmitters.
Within 10 seconds of the previous step, press any button on the RKE transmitter being programmed until a chime is heard. This indicates a new RKE transmitter code has been successfully programmed.
After each successful RKE transmitter programming, another 10 second learning mode is automatically entered, up to a maximum of 4 times.
To program additional RKE transmitters, repeat step 5.
The system exits the learning mode if the ignition switch is turned to position III, no new RKE transmitter is programmed during the 10 seconds, or if 4 RKE transmitters are programmed.

NOTE: An incorrect programming procedure does not affect the stored codes.

After successful programming, only the newly programmed RKE transmitters are accepted.
Test all the programmed RKE transmitters, by activating and deactivating the remote locking and unlocking functions.