Speed Control Deactivator Switch: Installation

CAUTION: Do not allow brake fluid to contact the electrical connector.

Install the deactivator switch.
- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
- Tighten to 18 Nm (13 lb-ft).
- Connect the electrical connector.
Fig 1: Adding Few Drops Of Brake Fluid To Fluid Port On Threaded Side Of Switch
Courtesy of FORD MOTOR CO.
Check the master cylinder fluid level and adjust as necessary.
Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .