Air Suspension Module

AIR SUSPENSION MODULE







Removal and Installation

1. CAUTION: Prior to removal of the module, it is necessary to upload the module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed.

Disconnect the battery.

2. Remove the 2 pin-type retainers from the instrument panel lower insulator and position the insulator aside.
3. Disconnect the power point electrical connector and the footwell lamp and remove the panel.
4. Disconnect the air suspension module electrical connectors.
5. Release the spring clips to remove the module from the bracket.

6. CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module.

To install, reverse the removal procedure.