Component testing procedure (Exterior Lights)
MULTIFUNCTION SWITCH - COMPONENT TESTING (EXTERIOR LIGHTS)
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | From C202a cavity 1, to C202b cavity 2. and C202a cavity 2 | Hazard switch to Normal (Off) and Turn switch to Left | Closed circuit |
| From C202a cavity 1, to C202a cavity 5 and C202a cavity 3 | Hazard switch to Normal (Off) and Turn switch to Right | Closed circuit | |
| Hazard | From C202a cavity 1, to C202a cavity 2, C202a cavity 3, C202a cavity 5, and C202b cavity 2 | Hazard switch to Hazard (On) (Button pushed in and then released to fully extended position) | Closed circuit |
| Brake Lights | From C202a cavity 4, to C202a cavity 5 and C202b cavity 2 | Turn switch to Neutral, hazard switch to Normal (Off) | Closed circuit |
| Flash-to-pass | From C202b cavity 9, to cavity 13, and From C202b cavity 11 to cavity 10 | Pull and hold lever stalk toward steering wheel | Closed circuit |
| High beam | From C202b cavity 9, to C202b cavity 10 | Lever stalk in detent away from steering wheel | Closed circuit |
| Low beam | From C202b cavity 9, to C202b cavity 12 | Lever stalk in neutral position toward steering wheel | Closed circuit |