Body Control Module: Service and Repair

VEHICLE SECURITY MODULE







Removal and Installation

1. CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.

Disconnect the battery.

2. Remove the RH A-pillar lower trim panel.
3. Remove the 2 vehicle security module nuts.
- To install, tighten to 12 Nm (9 lb-ft).

4. Disconnect the 2 electrical connectors and remove the vehicle security module.

5. NOTE: If installing a new module it is necessary to reprogram the remote keyless entry (RKE) transmitters.

To install, reverse the removal procedure.