Component Testing Procedure
MULTIFUNCTION SWITCH (13K359) COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohm-meter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 2 and 8 | Left turn | Closed circuit |
| 3 and 8 | Right turn | Closed circuit | |
| Flash-to-pass | 6 and 8 | Pull and hold lever stalk toward steering wheel | Open circuit |
| 4 and 8 | Closed circuit | ||
| High beam / Low beam | 6 and 8 | Lever stalk in detent toward steering wheel | Closed circuit |
| 4 and 8 | |||
| Hazard | 1 and 8 | Hazard On | Closed circuit |
| Hazard Off | Open circuit |