Drive Mode Procedure for GEAR

WARNING: This page is about a different variant/trim than selected.

NOTE: The OSC GEAR Mode is not allowed when the torque converter clutch is commanded ON. The normal transmission strategy may command the torque converter clutch to engage in 3rd gear when using OSC gear. If this occurs, the OSC gear will be cancelled and the PCM will command the normal shift schedule. Therefore, it is advisable to use the OSC "TCC" to command the torque converter clutch OFF before using OSC gear. Refer to TCC IN DRIVE MODE in this article.

Follow operating instructions from the scan tool menu screen:

Select "Output State Control."
Select "Trans-Drive Mode."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - GEAR."
Select Value "1-4."
Press "SEND" to send command.
Re-Select Value "1-4."
Press "SEND" to send command.
Select "XXX" to cancel at any time.
Press "SEND" to send command.