SSA, SSB in Bench Mode
WARNING: This page is about a different variant/trim than selected.
The BENCH Mode allows the technician to carry out electrical circuit checks on the following components:
- SSA - Activates SSA OFF or ON.
- SSB - Activates SSB OFF or ON.
OSC "SSA/B" BENCH Mode operates ONLY when:
- VSS and TR sensor are operational.
- No VSS and TR sensor DTCs.
- Transaxle range selector lever in P.
- Key ON.
- Engine OFF.
OSC Command Values:
- OFF - turns solenoid OFF.
- ON - turns solenoid ON.
- XXX - cancels OSC sent value.
- SEND - sends the values to PCM.
BENCH Mode procedure for SSA, SSB:
Follow operating instructions from the scan tool menu screen:
- Select "Output State Control."
- Select "Trans-Bench Mode."
- Select "PIDs" to be monitored.
- Monitor all selected PIDs during test.
- Select "Parameters - SSA, SSB (SS1, SS2)."
- Select "ON" to turn solenoid ON.
- Press "SEND" to send command.
- Select "OFF" to turn solenoid OFF.
- Press "SEND" to send command.
- Select "XXX" to cancel at any time.
- Press "SEND."