Toe Adjustment - Front

Using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.
Using alignment equipment and the manufacturer's instructions, measure the toe.
Loosen the tie-rod end jam nuts.

Fig 1: Locating Tie-Rod End Jam Nuts
Courtesy of FORD MOTOR CO.
Remove the steering gear boot outer clamps.

Fig 2: Locating Steering Gear Boot Outer Clamps
Courtesy of FORD MOTOR CO.
Rotate the tie rods as necessary to adjust the toe setting.

Fig 3: Rotating Tie Rods
Courtesy of FORD MOTOR CO.
Tighten the tie-rod end jam nuts to 55 Nm (41 lb-ft).

Fig 4: Locating Tie-Rod End Jam Nuts
Courtesy of FORD MOTOR CO.
Install the steering gear boot outer clamps.

Fig 5: Locating Steering Gear Boot Outer Clamps
Courtesy of FORD MOTOR CO.
Recheck the toe settings, adjust as necessary.