Dismounting/Mounting Procedures: Notes
CAUTION:
The tire should be dismounted from the wheel using the tire changer manufacturer's instructions. Use the following information to avoid damage during the dismounting/mounting procedures.
CAUTION:
The tire and wheel must always be correctly matched. It is very important to determine the size of each component before any assembly operations commence. Failure to adhere to these instructions can result in an explosive separation and cause serious bodily injury or death.
CAUTION:
Use only wheels and wheel nuts that have been designed for current model year Ford trucks. Tire pressure sensors are not designed to be used with aftermarket wheels. Aftermarket wheels or wheel nuts may not fit or function correctly, and can cause personal injury or damage to the vehicle. A wheel and tire assembly equipped with tire pressure sensor will have the following verbiage stamped or cast on the wheel: "Sensor May Be Inside".
CAUTION:
Retighten the wheel nuts at 500 miles (800 km) after any wheel change or any time the wheel nuts are loosened. Failure to retighten wheel nuts at the mileage specified can allow wheels to come off while the vehicle is in motion, possibly causing loss of vehicle control and collision.
NOTE:
The use of run-flat tires (tires with steel body cord plies in the tire sidewall) when vehicle is not originally equipped is not recommended, as it may cause TPM system to malfunction.
NOTE:
If possible, use Digital Tire Gauge (204-354) any time tire pressures are measured to be sure that accurate values are obtained. Ford recommends the use of a digital or dial type tire pressure gauge rather than a stick type gauge for increased accuracy.
CAUTION:
DO NOT inflate tire higher than maximum pressure stamped on tire sidewall.
To identify manufacturer part numbers for TPM system components, see TIRE PRESSURE MONITOR SYSTEM COMPONENTS table.
TIRE PRESSURE MONITOR SYSTEM COMPONENTS
| Application | Part Number | ||
|---|---|---|---|
| Tire Pressure Sensor/Sensor Kit | 1A150/1A189 | ||
| Strap/Strap Kit | 1A177/1A193 | ||
| Sensor Cradle | 1A175 | ||
| Locking Clip (1) | 14C202 | ||
|
|||