Specifications Index
FIVE HUNDRED, FREESTYLE & MONTEGO SPECIFICATIONS INDEX
| System | Specifications/Procedures | |
|---|---|---|
| Air Conditioning | ||
| Service | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut | ||
| Front | 258 Ft. Lbs. (350 N.m) | |
| Rear (4WD) | 258 Ft. Lbs. (350 N.m) | |
| Battery | GENERAL SPECIFICATIONS | |
| Brakes | ||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | |
| Disc Brakes | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT TENSIONER - MECHANICAL | |
| Belt Routing | ACCESSORY DRIVE | |
| Engine Cooling | ||
| General Service Specifications | GENERAL SPECIFICATIONS | |
| Radiator Cap Pressure | 13-18 psi (89-124 kPa) | |
| Thermostat R & I | THERMOSTAT | |
| Water Pump R & I | WATER PUMP | |
| Engine Mechanical | ||
| Compression | COMPRESSION TEST - COMPRESSION GAUGE CHECK | |
| Oil Pressure (minimum at 1,500 RPM with engine warmed up after 10 minutes of idling.) | 20 psi (138 kPa) | |
| Overhaul | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | 59 Ft. Lbs. (80 N.m) | |
| Fuel System | ||
| Fuel Filter Location | Left side of vehicle on frame rail mounted on bracket. | |
| Fuel Filter R & I | FUEL FILTER | |
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | |
| Pressure Specification | FUEL PRESSURE SPECIFICATIONS | |
| Fuel Pressure Test Procedure | A: No Start STEP A10 CHECK THE FUEL PRESSURE | |
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Coil (Cylinder Identification) | Coil on plug | |
| Ignition Wires (Routing) | Coil on plug | |
| Spark Plugs | ||
| Type (early build) | Motorcraft AGSF-32WM | |
| Type (late build) | Motorcraft AGSF-32N | |
| Gap | .052-.056 In. (1.32-1.42 mm) | |
| Torque | 11 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | GENERAL SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | ALIGNMENT SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 95 Ft. Lbs. (129 N.m) Torque specifications are for clean, dry bolt and nut threads. Never use oil or grease on wheel bolts or nuts. |
|