LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2006 >> Taurus SE, 3.0 U >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> General Procedures >> Selector Lever Cable Adjustment - Column Shift
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Selector Lever Cable Adjustment - Column Shift

NOTE: The selector lever cable adjustment procedure must be carried out in the order shown.
  1. Position the transaxle range selector lever in OVERDRIVE. Hang a 1.4 kg (3 lb) weight on the lever.
  2. Loosen the manual control lever-to-selector lever cable nut.
    Fig 1: Locating Manual Control Lever-To-Selector Lever Cable Nut - Column Shift
    G04710547Courtesy of FORD MOTOR CO.
  3. Position the manual control lever in OVERDRIVE then install the nut.
    • Tighten to 20 Nm (15 lb-ft).
    Fig 2: Locating Manual Control Lever-To-Selector Lever Cable Nut - Column Shift
    G04710548Courtesy of FORD MOTOR CO.
  4. Remove the 1.4 kg (3 lb) weight. Check the operation of the transaxle in each transaxle range selector lever position.
scientia non olet · About LEMON Manuals