LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Cutaway 6.8 S >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission - 5R110W - General Procedures, In-Vehicle Servicing, Removal, Disassembly, Disassembly And Assembly Of Subassemblies, Assembly, Installation >> Disassembly And Assembly Of Subassemblies >> Forward Planet Assembly >> Disassembly And Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly And Assembly

NOTE: Individual parts of the planet assemblies are not repairable.
Fig 1: Locating Lube Slinger
GF0006948Courtesy of FORD MOTOR CO.
  1. Remove the lube slinger.
    2. Fig 2: Removing Forward Clutch Thrust Bearing
    GF0006949Courtesy of FORD MOTOR CO.
  2. Remove the No. 12 forward clutch thrust bearing.
    3. Fig 3: Locating No. 11 Thrust Bearing
    GF0006950Courtesy of FORD MOTOR CO.
  3. Remove the No. 11 thrust bearing.
    4. Fig 4: Inspecting Forward Planet Assembly
    GF0006951Courtesy of FORD MOTOR CO.
  4. Inspect the forward planet assembly.
    • The pins and shafts in the plant assemblies should be checked for loose fit or damage. Use a new planet assembly if either condition exists.
    • Inspect the pinion gears for damaged or excessively worn teeth.
    • Check for free rotation of the pinion gears.
  5. To assemble, reverse the disassembly procedure.
    • Lightly lubricate the thrust bearings with petroleum jelly to hold them in place during assembly.
    • The No. 12 thrust bearing must be installed with the notched inner race facing outward.
scientia non olet · About LEMON Manuals