LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Cutaway 6.8 S >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission - 5R110W - General Procedures, In-Vehicle Servicing, Removal, Disassembly, Disassembly And Assembly Of Subassemblies, Assembly, Installation >> Disassembly And Assembly Of Subassemblies >> Reverse Planet Assembly >> Disassembly And Assembly >> All vehicles
April 5, 2026: LEMON Manuals is launched! Read the announcement.

All vehicles

Fig 1: Identifying No. 15 Sun Gear Thrust Bearing
GF0006974Courtesy of FORD MOTOR CO.
  1. Remove the No. 15 sun gear thrust bearing.
    2. Fig 2: Removing The Snap Ring
    GF0006975Courtesy of FORD MOTOR CO.
  2. Remove the snap ring. Disassemble the reverse ring gear and hub assembly. Inspect the components for damage. If damaged, install new components.
  3. To assemble, reverse the disassembly procedure.
    • Lightly lubricate the thrust washers with petroleum jelly to hold them in place during assembly.
    • The tabs on the thrust washers must engage the slots on the reverse planet assembly when installed.
    • The snap ring tips must be facing down toward the output shaft hub and fully engaged in the groove.
scientia non olet · About LEMON Manuals