Solenoid Body: Assembly

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Backing Plate Bolts

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Filter Screen Gasket

Courtesy of FORD MOTOR CO.

Fig 3: Locating Main Control Valve Body Bolts

Courtesy of FORD MOTOR CO.

NOTE: Tighten the bolts in a crisscross pattern to prevent the gasket from becoming distorted.

Assemble the top and bottom halves of the solenoid body.
- Tighten to 13 Nm (10 lb-ft).

Fig 4: Locating Transmission Fluid Temperature (TFT) Sensor

Courtesy of FORD MOTOR CO.

Fig 5: Locating Shift Solenoids With E-Clips

Courtesy of FORD MOTOR CO.

Fig 6: Locating Solenoid Body Electrical Connector O-Ring Seal

Courtesy of FORD MOTOR CO.

Install a new O-ring seal on the solenoid body electrical connector in the uppermost groove. Lubricate the O-ring seal with clean automatic transmission fluid.

Fig 7: Locating Main Control Valve Body Electrical Harness

Courtesy of FORD MOTOR CO.

Fig 8: Locating Manual Valve

Courtesy of FORD MOTOR CO.