LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Econoline E250, Van Cargo Extended, 5.4 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - 5R110W - General Procedures, In-Vehicle Servicing, Removal, Disassembly, Disassembly And Assembly Of Subassemblies, Assembly, Installation) >> In-Vehicle Servicing >> Transmission Support CROSSMEMBER >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Support CROSSMEMBER: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating Crossmember To Transmission Mount Nut
G03889185Courtesy of FORD MOTOR CO.
  1. Position the crossmember to the transmission mount and loosely install the nut.
    2. Fig 2: Locating LH Crossmember Bracket
    G03889062Courtesy of FORD MOTOR CO.
  2. Install the LH crossmember bracket.
    3. Fig 3: Identifying LH Crossmember Nuts
    G03889061Courtesy of FORD MOTOR CO.
  3. Install the LH crossmember bracket nuts.
    • Tighten to 81 Nm (60 lb-ft).
    4. Fig 4: Identifying RH Crossmember Bracket
    G03889064Courtesy of FORD MOTOR CO.
  4. Install the RH crossmember bracket.
    5. Fig 5: Identifying RH Crossmember Nuts
    G03889063Courtesy of FORD MOTOR CO.
  5. Install the RH crossmember bracket nuts.
    • Tighten to 81 Nm (60 lb-ft).
    6. Fig 6: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  6. Tighten the rear insulator nuts to 94 Nm (69 lb-ft).
    7. Fig 7: Heat Shield Screws
    GF0012415Courtesy of FORD MOTOR CO.
  7. Install the heat shield screws.
    • Tighten to 20 Nm (15 lb-ft).
    8. Fig 8: Identifying Wire Harness Retaining Clips
    G03889060Courtesy of FORD MOTOR CO.
  8. Install the wire harness and install the 2 retaining clips to the rear of the crossmember.
scientia non olet · About LEMON Manuals