LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Econoline E250, Van Cargo Extended, 5.4 L >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission - 5R110W - General Procedures, In-Vehicle Servicing, Removal, Disassembly, Disassembly And Assembly Of Subassemblies, Assembly, Installation) >> In-Vehicle Servicing >> Transmission Support CROSSMEMBER >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Support CROSSMEMBER: Removal

WARNING: This page is about a different variant/trim than selected.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Install a suitable high-lift transmission jack.
    3. Fig 1: Identifying Wire Harness Retaining Clips
    G03889060Courtesy of FORD MOTOR CO.
  3. Remove the 2 wire harness retainers from the rear crossmember and position the wire harness aside.
    4. Fig 2: Heat Shield Screws
    GF0012415Courtesy of FORD MOTOR CO.
  4. Remove the heat shield screws.
    5. Fig 3: Identifying LH Crossmember Nuts
    G03889061Courtesy of FORD MOTOR CO.
  5. Remove the LH crossmember nuts.
    6. Fig 4: Locating LH Crossmember Bracket
    G03889062Courtesy of FORD MOTOR CO.
  6. Remove the LH crossmember bracket.
    7. Fig 5: Identifying RH Crossmember Nuts
    G03889063Courtesy of FORD MOTOR CO.
  7. Remove the RH crossmember nuts.
    8. Fig 6: Identifying RH Crossmember Bracket
    G03889064Courtesy of FORD MOTOR CO.
  8. Remove the RH crossmember bracket.
    9. Fig 7: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  9. Remove the rear transmission mount nuts and the rear crossmember.
scientia non olet · About LEMON Manuals